Resistance Band Deadlift On FLEXICON
The FLEXICON deadlift builds the Glutes, Hamstrings and Back with band tension. There is no bar to drop and no plates to load, and the bands are lightest at the bottom, where the lower back is most exposed.
- Muscles Worked
- Glutes, Hamstrings · also Lower Back, Back, Forearms
- Equipment
- FLEXICON Tower
Machine Settings
- Clip Bands
- Connected to C-Ring 1, Around both pegs and then connected to C-Ring 4
- Loop Bands
- Connected to C-Ring 4, Around both pegs and then connected to C-Ring 3
- Handle Position
- Down, Bottom Position
How To Do It
- 1 Route the clip bands and loop bands around both pegs as in the settings, handles in the down, bottom position.
- 2 Stand in the tower, hinge at the hips and take the handles with a flat back.
- 3 Drive your hips forward to stand tall, then hinge back down under control.
Points To Remember
- Keep the handles close to your legs.
- Push the floor away with your feet instead of pulling with your arms.
- Finish standing tall, not leaning back.
Questions About The Deadlift
What muscles does the Deadlift work?
The Deadlift on FLEXICON works the Glutes and Hamstrings, with help from the Lower Back, Back and Forearms.
How do you set up the Deadlift on FLEXICON?
Clip Bands: Connected to C-Ring 1, Around both pegs and then connected to C-Ring 4. Loop Bands: Connected to C-Ring 4, Around both pegs and then connected to C-Ring 3. Handle Position: Down, Bottom Position. The set-up video on this page shows each setting.
Follow Along With The Deadlift
The free Bodylastics app has a set-up video for every FLEXICON exercise, plus starter challenges to follow. Its full library has more than 4,400 workouts in all, most of them general resistance band workouts.